Products - Do-It-Yourself Installation Kits







MPP 5.0 Kit





Do-It-Yourself Installation Kit MPP 5.0 - Powder contains TUNGUS MPP 5.0 module  pre-wired with USP-101 triggering sensor, mounting bracket base TCB-30-2, angle bracket TCB-10-1 and hardware required for the module and triggering sensor installation.

TUNGUS MPP 5.0 module can be installed vertically, horizontally or in any angled position as may be required by the application. It is specifically designed for use in suspended ceilings and raised floors because of its 360 degrees discharge. Extremely effective for fire protection in low height attic areas.

MPP 5.0 module has capacity to protect the entire room with square footage of up to 840 ft2 and 3,531 ft3. If equal protection of the entire rroom is required, the best results is achieved when the module is installed on the ceiling in the centre of the room. If mainly certain fire hazard spot protection is required, the best result is achieved when the module is installed right above (or in level with) the fire hazard spot.















MPP 5.0 Kit Package


















Previous Page


Next Page